Product ID:SPEEDHIDE S/G WHITE/PASTEL BASE, 6-510
MSDS Date:02/25/1999
FSC:8010
NIIN:00N029950
Status Code:A
MSDS Number: CJPLW

PPG INDUSTRIES INC

4325 ROSANNA DR
ALLISON PARK, PA 15101
US

Emergency Phone: 304-843-1300

Info Phone: 412-492-5555

Cage: 47695

PPG INDUSTRIES INC

PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3

ACGIH TLV: 10 MG/M3

SILICA 2482, HYDROPHOBIC; (SILICA)

CAS: 7631-86-9

RTECS: VV7565000

OSHA PEL 6 MG/M3

ACGIH TLV: 10 MG/M3

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INGESTION: HARMFUL IF
SWALLOWED. EYES: CAUSES IRRITATION. SKIN: MAY CAUSE SLIGHT
IRRITATION. INHALATION: VAPOR AND/OR SPRAY MIST MAY BE HARMFUL IF
INHALED. CHRONIC: AVOID LONG-TERM AND REPEATED CONTACT. THIS
PRODUCT CONTAINS TITANIUM DIOXIDE. ANIMALS INHALING MASSIVE
QUANTITIES OF TITANIUM DIOXIDE DUST IN A LONG-TERM STUDY DEVELOPED
LUNG TUMORS. STUDIES WITH HUMANS INVOLVED IN MANUFACTURE O F THIS
PIGMENT INDICATE NO INCREASED RISK OF CANCER FROM EXPOSURE.
POTENTIAL FOR INHALATION OF TITANIUM DIOXIDE DUSTS FROM COATINGS IS
VERY LIMITED. SINCE OVEREXPOSURES ARE NOT EXPECTED, THERE IS NO S
IGNIFICANT HAZARD FOR MAN.
Effects of Overexposure:REDNESS, ITCHING, BURNING SENSATION AND VISUAL
DISTURBANCES MAY INDICATE EXCESSIVE EYE CONTACT. DRYNESS, ITCHING,
CRACKING, BURNING, REDNESS, AND SWELLING ARE CONDITIONS ASSOCIATED
WITH EXCESSIVE SKIN CONTACT.
Medical Cond Aggravated by Exposure:NOT APPLICABLE.

First Aid:INGESTION: DO NOT INDUCE VOMITING. GENTLY WIPE OUT INSIDE
MOUTH TO REMOVE ANY RESIDUAL MATERIAL. EYES: REMOVE CONTACT LENSES
& FLUSH EYES IMMEDIATELY W/A GENTLE STREAM OF LUKE WARM WATER FOR
AT LEAST 15 MINUTES. SKIN: FLUSH IMMEDIATELY W/PLENTY OF WATER FOR
AT LEAST 15 MINUTES, FOLLOWED BY WASHING W/SOAP & WATER.
INHALATION: REMOVE TO FRESH AIR. APPLY ARTIFICIAL RESPIRATION &
OTHER SUPPORT MEASURE S AS REQUIRED. OTHER: IF INGESTION, ANY TYPE
OF OVEREXPOSURE OR SYMPTOMS OF OVEREXPOSURE OCCUR DURING OR
FOLLOWING USE OF THIS PRODUCT, CONTACT POISON CONTROL CENTER,
EMERGENCY ROOM OR PHYSICIAN IMMED IATELY; HAVE MSDS INFORMATION
AVAILABLE.

Extinguishing Media:USE EXTINGUISHERS APPROPRIATE FOR SURROUNDING FIRE.
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT . WATER SPRAY MAY BE INEFFECTIVE. WATER SPRAY MAY BE USED
TO COOL CLOSED CONTAINERS TO PREVENT PRESSURE BUILD-UP AND POSSIBLE
AUTOIGNITION OR EXPLOSION WHEN EXPOSED TO EXTREME HEAT. IF WATER
IS USED, FOG NOZZLES ARE PREFERABLE.
Unusual Fire/Explosion Hazard:KEEP PROD AWAY FROM HEAT, SPKS, FLAME &
OTHER SOURCES OF IGNIT (I.E., PILOT LIGHTS, ELEC MOTORS, STATIC
ELEC). INVISIBLE VAPS CAN TRAVEL TO SOURCE OF IGNIT & FLASH BACK.
DO NOT SMOKE WHILE USING PROD. KEEP CONTRS TIGHTLY CLSD WHEN NOT
IN USE. CLSD CONTRS MAY EXPLODE WHEN OVERHEATED. DO NOT APPLY TO
HOT SURFS. (SUP DAT)

Spill Release Procedures:PROVIDE MAXIMUM VENTILATION. ONLY PERSONNEL
EQUIPPED WITH PROPER RESPIRATORY, SKIN, AND EYE PROTECTION SHOULD
BE PERMITTED IN THE AREA. REMOVE ALL SOURCES OF IGNITION. TAKE UP
SPILLED MATERIAL WITH SA ND, VERMICULITE, OR OTHER NON-COMBUSTIBLE
ABSORBENT MATERIAL AND PLACE IN CLEAN, EMPTY CONTAINERS FOR
DISPOSAL. ONLY THE SPILLED MATERIAL AND THE ABSORBENT SHOULD BE
PLACED IN THIS CONTAINER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F (48C).
Other Precautions:VAPORS MAY COLLECT IN LOW AREAS. IF THIS MATERIAL IS
PART OF A MULTIPLE COMPONENT SYSTEM, READ MSDS FOR THE OTHER
COMPONENT OR COMPONENTS BEFORE HANDLING AS THE RESULTING MIXTURE
MAY HAVE THE HAZARDS OF ALL OF ITS PARTS. CONTAINERS SHOULD BE
GROUNDED WHEN POURING. AVOID FREE FALL OF LIQUIDS IN EXCES S OF A
FEW INCHES.

Respiratory Protection:WHERE VENT IS INADEQUATE, USE NIOSH APPROVED
AIR-PURIFYING RESPIRATOR W/APPROPRIATE CHEMICAL
CARTRIDGES/POSITIVE-PRESSURE, AIR-SUPPLIED RESPIRATOR. READ
RESPIRATOR MANUFACTURER'S INSTRUCTIONS & LITERA TURE CAREFULLY TO
DETERMINE TYPE OF AIRBORNE CONTAMINANTS AGAINST WHICH RESPIRATOR IS
EFFECTIVE, ITS LIMITATIONS, & HOW IT IS TO BE PROPERLY FITTED &
USED.
Ventilation:PROVIDE GEN DILUTION/LOC EXHST VENT IN VOL & PATTERN TO
KEEP CONC OF INGS LISTED BELOW LOWEST SUGGESTED EXPOS LIMS, LEL
BELOW STATED LIM, & TO REMOVE (SUP DAT)
Protective Gloves:GLOVES SHOULD BE CONSTRUCTED OF IMPERMEABLE MATERIAL.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EMER EYEWASH & DELUGE SHOWER .
WEAR PROT CLTHG. NO SPECIFIC PERMEATION/DEGRADATION TESTING HAVE
BEEN DONE ON PROT CLTHG FOR PROD. RECS FOR SKIN PROT ARE BASED ON
INFREQUENT (SUP DAT)
Work Hygienic Practices:CLEAN CONTAMINATED CLOTHING AND SHOES.
Supplemental Safety and Health
EXPLO HAZ: TOX GASES MAY FORM WHEN PROD COMES IN CONT W/EXTREME HEAT.
VENT: DECOMP PRODS DURING WELDING/FLAME CUTTING. OTHER PROT EQUIP:
CONT W/PROD. FOR FREQUENT CONT/TOTAL IMMERSION, CONT MFR OF PRO T
CLTHG FOR APPROP CHEM IMPERVIOUS EQUIP. PHYSICAL/CHEM PROPERTIES:
WT/GAL: 9.95 LBS (U.S.); % SOLIDS BY WT: 38.59.

Boiling Pt:>100.C, 212.F
B.P. Text:212F - 475F
Vapor Pres:17.4 MMHG
Vapor Density:HVR/AIR
Spec Gravity:1.194
Evaporation Rate & Reference:35 (BUTYL ACETATE=100)
Solubility in Water:69.7%
Appearance and Odor:VISCOUS LIQUID W/AN ODOR CHARACTERISTIC OF SOLVENTS
LISTED IN INGS SECTION.
Percent Volatiles by Volume:72.130

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE THE FOLLOWING HAZARDOUS
DECOMPOSITION PRODUCTS WHEN EXPOSED TO EXTREME HEAT: OXIDES OF
ALUMINUM, CARBON MONOXIDE, CARBON DIOXIDE, LOWER MOLECULAR WEIGHT
POLYMER FRACTIONS. (OTHER INFO)

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, PROVINCIAL, AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WA STE MANAGEMENT FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

SARA Title III Information:SARA 311/312 CATEGORIES FOR THIS PRODUCT:
ACUTE=N, CHRONIC=N, FLAMMABILITY=N, PRESSURE=N, REACTIVITY=N. SARA
102 RQ (LBS): NOT ESTABLISHED. SARA 302 TPQ (LBS): NOT ESTABLISHED.
SARA 313: N.
Federal Regulatory Information:THIS MATERIAL SAFETY DATA SHEET HAS BEEN
PREPARED IN ACCORDANCE WITH THE OSHA HAZARD COMMUNICATION STANDARD
(29 CFR 1910.1200), THE SUPPLIER NOTIFICATION REQUIREMENTS OF SARA
TITLE III, SECTION 313, A ND OTHER APPLICABLE RIGHT-TO-KNOW
REGULATIONS. ALL CHEMICAL SUBSTANCES IN THIS PRODUCT ARE LISTED ON
THE U.S. TSCA INVENTORY OR ARE OTHERWISE EXEMPT FROM TSCA INVENTORY
REPORTING REQUIREMENTS.